Showingof 4246 item(s)
Traxxas 8554 Rebuild kit, steel constant velocity driveshaft (includes drive pin & cross pin for two driveshaft assemblies)
$4.00
Traxxas 5243 Throttle arm, carburetor/ 3mm set screw (1-each) (TRX® 2.5, 2.5R)
$6.00
Traxxas 5236 Head, water-cooled marine (TRX® 2.5, TRX® 2.5R)
$20.00
Ball bearings, 7x17x5mm (1)/ 12x21x5mm (1) (TRX® 3.3, 2.5R, 2.5 engine bearings)
Engine ball bearings (7x17x5 mm) and (12x21x5 mm) for TRX® 2.5, 2.5R, and 3.3 engines.
Engine ball bearings (7x17x5 mm) and (12x21x5 mm) for TRX® 2.5, 2.5R, and 3.3 engines.
$30.00
Traxxas 5219 Crankshaft, IPS (for engines w/ starter) (TRX® 2.5, 2.5R)
$36.50
Wheelie bar, blue (assembled)/ 3x20 CS (8)
The Sledge® wheelie bar helps prevent backflips under full-throttle acceleration and flexes to absorb impacts on less-than-perfect landings. It also features a convenient handle to transport your Sledge to the
The Sledge® wheelie bar helps prevent backflips under full-throttle acceleration and flexes to absorb impacts on less-than-perfect landings. It also features a convenient handle to transport your Sledge to the
$28.00
Turnbuckles, aluminum (blue-anodized), camber links, front, 39mm (2), rear, 49mm (2) (assembled w/rod ends & hollow balls)/ wrench
Traxxas’ aluminum front and rear camber links make it easy to add strength and adjustability to your Traxxas model. These a
Traxxas’ aluminum front and rear camber links make it easy to add strength and adjustability to your Traxxas model. These a
$22.00
Connector, 25.2 volt to 14.8 volt jumper (allows a Traxxas® dual-battery 25.2 ESC to run on a single 14.8V battery pack)
Use the battery jumper on Traxxas dual-battery 25.2-Volt electronic speed controls when using a single 4-cell LiPo battery pack.
Acc
Use the battery jumper on Traxxas dual-battery 25.2-Volt electronic speed controls when using a single 4-cell LiPo battery pack.
Acc
$6.50
Traxxas 3483 Motor, 2000Kv 77mm, brushless (with 6.5mm gold-plated connectors & high-efficiency heatsink)
$149.95
Spacers, steel (Jato® twin-spoke wheels, front) (4)
$2.75
Connector, power tap (with cable)/ 2.6x8 BCS (2) (use #6549 power tap for telemetry voltage)
The power tap connector plugs inline between the battery and ESC to provide power to an optional LED power supply. Includes 2.6x8 mm screws (2).
The power tap connector plugs inline between the battery and ESC to provide power to an optional LED power supply. Includes 2.6x8 mm screws (2).
$6.00
LED light set, complete (includes front and rear bumpers with LED light bar, rear LED harness, & BEC Y-harness) (fits 2WD Slash®)
$49.95
Ball bearings, blue rubber sealed (10x15x4mm) (2)
$7.00
Ball bearings, blue rubber sealed (6x10x3mm) (2)
$4.00
Bullet connectors, male, 3.5mm (3)/ heat shrink
Male 3.5 mm bullet connectors (3) with heat shrink tubing
Replacement part for these models:
Bandit® VXL
Rustler® VXL
Stampede® VXL
Male 3.5 mm bullet connectors (3) with heat shrink tubing
Replacement part for these models:
Bandit® VXL
Rustler® VXL
Stampede® VXL
$5.50
Traxxas 9513X Body support (assembled with front mount & rear latch)/ skid pads (roof) (left & right)
$32.00
Traxxas 5972A Wheels, SCT satin chrome with red beadlock, dual profile (2.2' outer, 3.0' inner) (2)
$11.00
Traxxas 5934X Suspension arm upper (1)/ suspension arm lower (1) (left rear) (fits Slayer Pro 4X4)
$7.50
Traxxas 8260A Shocks, GTS, aluminum (blue-anodized) (assembled with spring retainers) (2)
$40.00
Oil, differential (20M wt) (standard)
Super-thick 20 million weight differential oil has the consistency of thick putty and is most often used in center differentials. It may also be used to lock front or rear differentials when equal power transfer to b
Super-thick 20 million weight differential oil has the consistency of thick putty and is most often used in center differentials. It may also be used to lock front or rear differentials when equal power transfer to b
$15.00